PCS / PulseWorx UPB Powerline Interface For ELK M1 System

Description

The PIM-E is identical to the ELK-M1PCSPIM.

It is a special Power Line Interface Module containing a built-in M1XSP Serial Port chip. This all-in-one device makes it easy to permanently connect the ELK M1 Control to a UPB network. Simply locate a convenient unused AC Power Outlet, connect a cable from the M1 data bus to the four (4) terminals on the PIM-E, and perform an M1 data bus enrollment. The long distance capability of the M1 data bus makes it possible to locate the PIM-E virtually anywhere, without a lot of complex or ugly cabling or connections. UPB utilizes the AC wiring circuit for transmission, without new or additional wiring, and without radio frequency signals.

Features

All-in-one device for interfacing M1 with UPB.
Compact interface requires small amount of space
Easy hookup -- requires only the 4-wire data bus connection.
NO 9-Pin Serial Cable
Includes UPB Status light (multicolored) AND a M1 Data Bus Status Light (Green) -- enhances the ability to diagnose and troubleshoot
Removable 4-pin terminal block connection

Specifications

Current Draw from M1	~30mA @ 12 VDC
M1 Bus Device Address	Preset at Address #7 [Requires bus module enrollment]
Firmware required	1.0.42 (std. firmware) or later
Power
	UPB Network circuitry - powered from the AC "Primary" Line.
	M1 Data Bus Device circuitry - powered (12VDC) from the M1
	Data Bus (+) & (-) terminals.
	NOTE: Loss of AC primary power should not result in a
	missing data bus device trouble.
PO-PIME Replaces	ELK Products, Inc. M1PCSPIM UPC 762158550737
UPC PIM-E	811976012757