Audioplex Emitters
IRBUG-PL
Adjustable IR bug, Plug in |
|
|---|
- Connector: Screw-type, 2 wire
- Mounting: IRBug: Directly to the front panel of each A/V component
- Range: 10 -15 feet +,
- Angle: +/-20-30 degrees off nominal axis. +/- 50-60 degres off axis.
- Wire: Use conventional unshielded "zip" or telephone wire.
- IRBUG PDF
| |
Have you ever been frustrated trying to set up a system and having the emitter overpower its intended target? Time spent trying to find the "sweet spot" on a component not onbly costs you money, but can also make for unreliable infrared performance.
Audioplex has solved this signal strength problem with the introduction of the Adjustable IRBug*. By simply turning the adjustment screw, you can fine tune the signal strength of the emitter to perfectly match any component in your system!
Available in both hard-wire and plug-in versions, you can now feel confident that you are always sending the perfect signal.
| |
|
IRBUG-HW
Adjustable IR bug, hard wired |
|
|---|
- Connector: Screw-type, 2 wire
- Mounting: IRBug: Directly to the front panel of each A/V component
- Range: 10 -15 feet +,
- Angle: +/-20-30 degrees off nominal axis. +/- 50-60 degres off axis.
- Wire: Use conventional unshielded "zip" or telephone wire.
- IRBUG PDF
| |
Have you ever been frustrated trying to set up a system and having the emitter overpower its intended target? Time spent trying to find the "sweet spot" on a component not onbly costs you money, but can also make for unreliable infrared performance.
Audioplex has solved this signal strength problem with the introduction of the Adjustable IRBug*. By simply turning the adjustment screw, you can fine tune the signal strength of the emitter to perfectly match any component in your system!
Available in both hard-wire and plug-in versions, you can now feel confident that you are always sending the perfect signal.
| |
|
IRFLOODPL
IR Flood Emitter |
|
|---|
- Flooding IR Emitter
- Includes double-stick tape.
- 1/8" Male mono plug on 6' cable.
- For best results, use IRPRISMs (below) on each component.
- Also available in hard wired version
| |
Flooding IR Emitter simplifies systems where two or three components are placed in one shelf and can be flashed with the ultra-powerful IRFloods. Mount in front, above, below or on the side of the components, the IRFlood saturates each component in the shelf space.
| |
|
TB-T
IR Flood Emitter In A Chassis |
|
|---|
- Flooding IR Emitter
- TB-T has a 10' range on axis.
- Wire with standard 2 -conductor zip or speaker wire.
- For best results, use IRPRISMs (below) on each component.
- Instruction Manual (PDF)
| |
Flood from a discrete black chassis.
| |
|
IRPRISM
IR Prism |
Without IRPrism
With IRPrism
|
|---|
- Allows IR from the front, side, top, or bottom to be detected by your components.
- Use with IRFLOOD (above).
| |
The revolutionary and patented IRPrism is an Audioplex exclusive. This unique product is placed over the front of A/V component's IR sensors, will reflect incoming signals from your repeater system's emitters placed at the side, top or bottom of the units. IRPrisms attach directly to components via their self-adhesive stick pad. Get rid of unsightly emitter wires running across the front of high-end gear and improve off-axis remote control response in open cabinets with the IRPrism!
| |
|
|
