You must set your browser to accept cookies and to enable Javascript in order to access certain functions of this site.

This is the old HomeTech Solutions website.
Please visit our new website here

Addressable IR Router

IR Routers are switchers which direct an infrared control signal to any one or any combination of outputs. Now you can control large groups of TV monitors (or any other A/V product) from control locations using Xantech IR Receivers or Smart Pads. Up to 16 devices may be addressed with one RT16; 8 can be addressed with the RT8. In addition, the "I" and "G" output ports can drive LED indicators placed at each controlled device location so that you can see which devices are being addressed at any given time.

CATEGORY
Modes of Operation
Features & Functions

Related Links
Infrared Emitters
Infrared Distribution Blocks

Modes of Operation

An Id Code Switch sets specific programming modes as follows:

Single Routing

Allows any individually selected port to be driven with an IR control signal separate from the others.

Multiple Routing (RT16 only)

IR control signals can be routed to any desired combination of ports (1 through 16) for simultaneous operation. This is useful if you wish to address smaller groups of units for special purposes.

The chosen IR routes remain on, allowing you to control just the selected devices, until the Group Off command from the RC68+ is sent. You may make up sequences (macros) in a learning device (such as the Xantech SmartPads) for each routing combination you desire for rapid access to the controlled groups.

Group ON

In this mode all 8 or 16 IR routes are chosen simultaneously with the Group On command. This is useful if you wish to quickly address all IR outputs at the same time.

Group OFF

Turns the IR signal off at all IR outputs

Xantech
Authorized Xantech Dealer

Addressable IR Routers

16-Port Router Shown

Responds to Xantech RC68+ Hand Held Programmer codes to address 8/16 individual ports.
Capable of being set to 55 different code groups. The code groups are identified by the numbers and letters that are on the face of each button on the RC68+.
A 4-terminal plug-in connector, "IR RCVR INPUT", permits connection of all Xantech IR Receivers, Keypads, Controllers, etc.
A green LED adjacent to the "IR RCVR INPUT" serves as an input signal Test-IR.
RT8 has 8 IR "O" and "G" emitter outputs and 8 "I" and "G" indicator outputs located on eight 4-terminal plug-in connectors
RT16 has 16 IR "O" and "G" emitter outputs and 16 "I" and "G" indicator outputs located on sixteen 4-terminal plug-in connectors.
The "I" and "G" indicator outputs are current limited to 10 mA (25 mA for RT16), allowing the direct connection of an LED without the need for a current limiting resistor.
Power Requirements: 12V DC @ 1 Amp.
Power Supply 78600 required for each RT8. Power Supply 78200 required for each RT16 (or up to 5 RT8's).
Requires RC68+ Programmer.
Universal mounting on the RT16 fits 19" racks.

	XA-RT8 Addressable RT Router,8port Xantech/Videolink		For ordering information, please see this item on our current website.
	XA-RT16 Addressable RT Router Xantech/Videolink		For ordering information, please see this item on our current website.